Introduction
- Tutorial Objective: Explain how to perform the necessary measurements for sizing the main bearings of VW Type 1 engines.
- Importance of Main Bearings: Understand their role in engine operation and the consequences of incorrect sizing.
Required Materials
- Caliper or Micrometer
- Depth Gauge
Measurement Steps
1. Measuring the Crankshaft
Determine the size of the crankshaft: Check if the crankshaft is standard size or if it has been machined.
Take the measurements:
- Standard size: 54.95 mm
- First oversize: 54.70 mm
- Second oversize: 54.45 mm
- Third oversize: 54.20 mm
- Fourth oversize: 53.95 mm

2. Measuring the Main Bearing Housing in the Engine Block
Measure the inner diameter of the main bearing housing in the assembled engine block without the bearing.
Sizes:
- Standard size: 65.0 mm
- First oversize: 65.5 mm
- Second oversize: 66.0 mm
- Third oversize: 66.5 mm
- Fourth oversize: 67.0 mm

3. Measuring the Main Thrust
Importance of the Thrust Bearing: Absorbs front and rear loads from the clutch and transmission.
Measure the thickness of the last bearing contact on the flywheel side.
Sizes:
- Standard size: 22 mm
- First oversize: 21 mm
- Second oversize: 20 mm

Measure Verification
- Compare the obtained measurements with the specifications to ensure they match or are within acceptable tolerances.
Conclusion
- Summary of Key Points: The importance of measurement accuracy to prevent engine failures.
- Next Steps: Select and purchase suitable bearings based on the taken measurements.
Français
Español
Deutsch

