Explanation of ET for Selecting Rims for Your Beetle
ET (Einpresstiefe) is a crucial measurement when choosing new rims for your vehicle. It helps ensure that the rims you select will fit correctly on your Beetle without causing performance or safety issues. Here is a simple and clear explanation of this concept:
1. What is ET?
ET, or offset in English, is the distance between the mounting surface of the rim and the centerline of the rim. It is an important measurement because it determines how the rims will be positioned relative to the wheel wells.
2. How is it Measured?
To measure ET, follow these steps:
- Determine the total width of the rim.
- Identify the centerline of the rim (halfway between the two edges).
- Measure the distance between the mounting surface of the rim (the part that touches the hub) and this centerline.
3. Importance of Offset (ET)
ET is usually indicated in millimeters and can be:
- Positive (+): The mounting surface is towards the outside of the centerline of the rim. This brings the rims closer to the vehicle.
- Negative (-): The mounting surface is towards the inside of the centerline of the rim. This pushes the rims further from the vehicle.
4. How ET Affects Your Vehicle
Incorrect ET can cause several issues:
- Contact with the wheel well: If the ET is too wide, the rims can rub against the wheel wells.
- Tire wear: Incorrect ET can lead to uneven tire wear.
- Handling problems: Incorrect ET can affect the handling and stability of your vehicle.
5. Example of ET Calculation
Suppose you have a rim that is 7 inches wide with an ET of +35 mm:
- Convert the width to millimeters: 7 inches x 25.4 = 177.8 mm
- Half of this width is 88.9 mm.
- The ET of +35 mm means that the mounting surface is 35 mm towards the outside relative to the centerline.
- The total distance from the outer edge driver side to the centerline would then be 88.9 mm + 35 mm = 123.9 mm.
6. Selecting Rims for Your Beetle
When choosing rims for your Beetle, make sure to check:
- Compatibility with the model of your Beetle.
- Specifications of width and offset.
- The impact of ET to ensure proper fit without major modifications.
Illustrative Diagram

The diagram above shows how to measure ET, including the total width of the rim and the offset.
Conclusion
Choosing the right rims for your Beetle using ET will help ensure safe driving and optimal performance. If you have any doubts, do not hesitate to consult a professional for advice tailored to your vehicle.
Français
Español
Deutsch

Right rear wing for VW Beetle 1200 / 1303 since 1975 - Ref. 111821306R
Front Apron 4 Finger Beetle Type 1 1.2 08/1949-08/1960
Left Front Bracket Support with Bumper Reinforcement for Volkswagen Beetle 1302/03, 1971-1973.
