Installing Whitewalls (whiteband trims)

Add a retro style to your Volkswagen Aircooled without changing tires: this step-by-step guide shows how to properly install removable whitewall trims on radial or bias-ply tires, covering preparation, fitting, inflation, and maintenance.

VW Tech Workshop Aircooled
Final result: whitewall tire on chrome Volkswagen rim
Final result: whitewall centered, no wrinkles.

Contents

Compatibility & requirements

Suitable for steel, alloy, or wire wheels. On radial tires, choose a profile of 75 minimum (e.g. 165/80R15) for best results. New tires should be driven and heated through several cycles to eliminate mold-release wax.

Safety: remove the wheel, work on a stable surface, fully deflate before installation. Avoid any contact between the trim and the road/curbs during maneuvers.

1) Preparation

  1. Remove the wheel and fully deflate the tire.
  2. Clean the sidewall, especially under the outer lip: use panel wipe / brake cleaner. Do not use white spirit, household alcohol, turpentine.
  3. The rubber must appear matte (sign it is clean and grippy).
Chrome VW rim with tire before whitewall installation
Wheel ready: deflated and sidewall fully degreased.

2) Fitting the whitewall

Positioning the whitewall trim on VW tire
Position the whitewall on the deflated sidewall.
Inserting the whitewall lip between rim and tire sidewall
Gradually insert the lip between rim and sidewall without stretching.
Adjusting the whitewall with rubber mallet or palm
Tap so the lip is fully engaged all around.
Checking whitewall near inflation valve
Careful check near the valve and tighter areas.

3) Inflation & checks

Inflating tire with whitewall trim fitted
Inflate gradually to nominal pressure.
  • If the lip pops out during inflation: residue remains → re-clean until matte.
  • If a crease/bulge appears: deflate, re-center, re-inflate.
  • Check visual centering all around (regular gap between rim and trim).

Tip: a thin layer of Castrol Red Rubber Grease between trim and sidewall reduces friction (especially on radials).

Adjustment after first inflation

During the first inflation, the whitewall may shift slightly against the rim. This is normal, as the pressure pushes the trim into its seat.

Whitewall shifted after first inflation, requiring repositioning
Visible offset: alignment mark not level with rim.
Manual repositioning of whitewall after deflation
Correct by deflating, repositioning, then re-inflating.

If the trim’s alignment mark is too far from the steel rim, the fit is incorrect.
Solution is simple:

  • Fully deflate the tire.
  • Reposition the whitewall uniformly all around.
  • Re-inflate gradually while checking alignment visually.

Tip: repeat this process 2 or 3 times if needed until the whitewall sits perfectly and stays stable at nominal pressure.

Maintenance & care points

  • Avoid curb contact (risk of tearing). If impact occurs, remove and inspect.
  • Cleaning: water + mild detergent, Brillo-type sponge for stubborn stains.
  • Rubber lubrication must be checked and renewed regularly to reduce heating and wear.
  • On low-profile radials (< 70), prefer narrower trims to stay within sidewall radius.

Buy Whitewalls

Check out our selection for classic vehicles (VW, US-cars, oldtimers). Widths and diameters from 10″ to 21″.

View category
whitewalls for classic vehicles – Dream Machine category
Rédigé par Atelier Dream Machine
  • Publié le 15 septembre 2025